Not Tumbling
Maytag Electric Dryer

Learn How To Fix A Not Tumbling Maytag Electric Dryer 

If your Problem is a not tumbling Maytag electric dryer.

You will need to check the following parts until you find out the part that needs to be replace to fix the dryer.

Here I am going to give you a brief description of the parts you need to check, and below you will have the links to the pages with the videos that will show you how the repairs are done.

Taking Apart

To fix a not tumbling Maytag electric dryer, you need to learn how to take it apart and put it back together again properly.

When you know how to dismantle the dryer, every repair becomes easier do. The hardest thing to do when making a repair is dismantling and reassembling the dryer.

So my advice to you is, learn how to dismantle and put the dryer back together properly, before trying to do the repairs.

Click Here To See The Video

The Belt

The dryer uses a skinny belt about 1/4 inch to turn the tumbler. With time and uses the dryer either breaks or gets stretch preventing the tumbler from turning fast enough of not turning at all.

The easier way to check to see if the belt is broken is by opening the dryer door and trying to turn the drum. If it turns easily, most likely the belt is broken or derailed. Is hard to explain how to replace the belt with words but the video below will show you step by step how to replace it. 

Click Here To See The Video-1

Click Here To See The Video-2

The Idler pulley

The idler pulley is used to give the belt the proper tension. It consist of a bracket, a wheel and a spring. The belt goes around the drum and then around the wheel on the idler pulley.

With time the center of the wheel wears out and the wheel doesn't run even anymore and the belt derails. Check the videos below according to the idler pulley in your dryer.

Click Here To See The Video-1

Click Here To See The Video-2

Rear Drum Support Rollers

These dryer use 2 rear drum support rollers the drum rides on top of them. Worn out rollers tend to get noisy and don't allow the drum to turn the way that they supposed to. Usually 1 roller is the ones giving you problems, but since you have to open the dryer to replace it, you should replace both rollers at the same time. 

Click Here To See The Video

Front Drum Glides / Slides

The front of the drum turns on 2 pieces of Teflon glides or slides that are riveted to the front drum support panel. When they wear out the drum starts to rub metal to metal wearing the metal on the panel and the drum. The dryer starts to make rubbing noises and the noises get louder as the slides wear out more. Check the video below to see how to replace them.

Click Here To See The Video

You will need to make sure to watch the videos a few times until you know how to fix a not tumbling Maytag electric dryer. Never assume that a part is bad without checking it and make sure it is bad before replacing it.

Another thing that you need to do is to learn how to check, remove and install the parts before starting to buy replacement parts.

Make sure that the company that you buy parts from give you a good return guarantee in case that you may need to return any parts.

WE recommend  Repair Clinic  for their 365 days return guarantee

Also take the purchase slip and the old part and put them in the box of the new part so in case you need to return any parts you will know where the box and the slip are.

This the end of the not tumbling Maytag electric dryer page.

Home Page

© Copyrighted 2017 2018 Angel Acevedo. All rights reserved