The videos in this page are provided to help you learn what parts you need to check and replace to fix your Maytag 2 belts original washer when is not spinning. Watch the videos a few times until you know how to do what I am showing you in the videos.
I also provide you with links to the parts needed to complete each repair. The links will take you to Amazon.com where you could get the lowest prices on replacement parts.
If you buy the parts from Amazon. com using the links we provide you, we will get a small commission that will help us to continue making more free videos.
Thank you for your support
These Maytag washer uses 2 belts. One belt to turn the transmission and the other bel to turn the water pump. These belts last a very long time if the washer is spinning or agitating properly. Watch the video below to see how to properly remove and replace the belts.
The springs and slide are use to automatically adjust the tension of the belts. They are mounted on the motor plate and when they are working properly the belts tension is done as needed. But you need to make one adjustment when you install the belts and then they should work properly. Watch the video below to see how to clean the motor mounting plate and install the springs & slides.
This washer when it start to drain the water out of the tub it also start to slow spin. As the washer is draining out the speed of the spinning drum will increase. So if there are any obstructions preventing the washer from draining, the washer is not going to spin properly. Watch this video to see how to properly remove obstructiosns.
DISCLAIMER: This website contains Amazon affiliate links, which means that if you click on one of the product links, and buy the product I’ll receive a small commission. This help support the channel and allows us to continue to make more free videos available to you . Thank you for your support!
© Copyrighted 2018 2019 Angel Acevedo. All rights reserved