Not Draining
Maytag Washer

Learn How To Fix A Not Draining Maytag Washer 

To fix a not draining Maytag washer you will need to know what parts you need to check according to the problem.

Below you will find the descriptions of the parts and the videos that will show you how to check the parts, how to remove them and how to install the new parts.

The Water Pump

A bad water pump could be the reason why your washer is not removing the water from the tub. It could have a worn out impeller, a frozen impeller to the center bearing in the pump. Also make sure that the belt is turning the pumps pulley at the right speed. Also there could be something stuck inside of the pump.

To check it out you will need to do the following. Disconnect the washer from the wall outlet. Use a bucket and a plastic cup to bail out any washer inside of the tub. After bailing out the water, you will need to remove the front panel to get access to the pump.

Click Here To See The Video


Items like small socks, curtain ties, and baby items of clothing could find their way into the tub of the washer and obstruct the flow of water during the drain cycle. To check for obstructions you will need to do the following.

Disconnect the washer from the wall outlet. Bail out any water from the tub. To bail the water you could use a bucket and plastic container to scoop the water. After removing the any water from the tub, put a couple towel on the floor to catch any water that may still in the pump.

Open the front panel and remove the tub to pump hose and check for obstructions. Then disconnect the pump to drain hose and check it out.

As you could see if any of these parts fails to work properly it could stop the washer from removing the water from the washers tub and you wind up with a not draining Maytag washer problem.

Click Here To See The Video

You will need to make sure to watch the videos a few times until you know how to fix a not draining Maytag washer. Never assume that a part is bad without checking it and make sure it is bad before replacing it.

Another thing that you need to do is to learn how to check, remove and install the parts before starting to buy replacement parts.

Make sure that the company that you buy parts from give you a good return guarantee in case that you may need to return any parts.

WE recommend  Repair Clinic  for their 365 days return guarantee

Also take the purchase slip and the old part and put them in the box of the new part so in case you need to return any parts you will know where the box and the slip are.

This the end of the not draining Maytag washer page.

Home Page

© Copyrighted 2017 2018 Angel Acevedo. All rights reserved