Not Agitating
Maytag Washer
 




Learn How To Fix A Not Agitating Maytag Washer 



To fix a not agitating Maytag washer you will need to know what parts you need to check according to the problem.

Below you will find the descriptions of the parts and the videos that will show you how to check the parts, how to remove them and how to install the new parts.




The Agitator

A stripped agitator spline could cause the agitator to turn too slow leaving the clothes dirty. This doesn't happened too often, but could happened.




The Belts

This washer uses 2 belts. The motor to transmission belt is used to make the washer spin or agitate. The motor to pump belt is used to turn the pump to drain the water from the washer.

The age and the amount of time that you use the washer has to do with how fast the belts wear out. When the belts wear out, they tend to slip and grab the transmission pulley less ,slowing down the agitator action. The link below will show you how to remove and replace the belts.

Click Here To See The Video




Motor Springs & Slides

The motor is mounted on  2 metal plates that use 4 slides and 2 springs to give the belts the proper tension to agitate or spin the drum.

The metal plates mount one inside of the other and dirt sometimes prevent the springs from giving the motor the proper tension. The video on the link will show you how this repair is done.

Click Here To See The Video




The Transmission

The oil on the older transmission could get thick when the washer is located on a place that gets cold. Thick oil will cause the gears in the transmission to turn too slow to wash the clothes at the right speed to clean it.

As you could see if any of these parts fails to work properly it could stop the washer from washing the clothes properly.

Click Here To See The Video-1

Click Here To See The Video-2



You will need to make sure to watch the videos a few times until you know how to fix a not agitating Maytag washer. Never assume that a part is bad without checking it and make sure it is bad before replacing it.

Another thing that you need to do is to learn how to check, remove and install the parts before starting to buy replacement parts.

Make sure that the company that you buy parts from give you a good return guarantee in case that you may need to return any parts.

WE recommend  Repair Clinic  for their 365 days return guarantee

Also take the purchase slip and the old part and put them in the box of the new part so in case you need to return any parts you will know where the box and the slip are.

This is the end of the not agitating Maytag washer page.








Home Page




© Copyrighted 2017 2018 Angel Acevedo. All rights reserved