Noisy
Maytag Washer
 




Learn How To Fix A Noisy Maytag Washer 



To fix a noisy Maytag washer you will need to know what parts you need to check according to the problem.

Below you will find the descriptions of the parts and the videos that will show you how to check the parts, how to remove them and how to install the new parts.




Take Apart

The first thing that you need to learn to be able to fix your Maytag top load washer, is how to remove any panel to get access to the parts inside of the washer. Once you learn this, it will be very easy to do most repair in the washer. 

Click Here To See The Video




The Motor

The most common cause for the motor to make noises is worn out bearings. This motors are what is called throw away motors, in other words they are not repairable. If the bearings are bad, you will need to replace the motor.

Click Here To See The Video-1

Click Here To See The Video-2

Click Here To See The Video-3





Water Pump

Same thing that the motor, if the impeller bearings wear out, the impeller will rub against the pump body and will get noisy.


Click Here To See The Video




Radial Bearing

If the washer leaks water through stem & seal, the water will end up on top of the radial bearing and the bearing will get rusted and it will sound like an helicopter taking off. In this case you will need to replace the stem & seal kit, the tub bearing and the radial bearing too. 

Click Here To See The Video




The Transmission

The internal parts of the transmission sometimes wear out causing the transmission to run noisy. The solution to this problem is replacing the transmission. There is a link to a video below that will show you how to remove and replace the transmission.

Click Here To See The Video-1

Click Here To See The Video-2




Damper Pads

When the damper pads get unglued and fall out of place the complete tub assembly stars to ride metal to metal and the washer starts to shake all over the place. The solution to this problem is installing new damper pads.

Click Here To See The Video




Brake Assembly

A dry brake assembly could also be the cause of a noisy Maytag washer. The brake could make noise when the pads inside are too dry.

Click Here To See The Video



You will need to make sure to watch the videos a few times until you know how to fix a noisy Maytag washer. Never assume that a part is bad without checking it and make sure it is bad before replacing it.

Another thing that you need to do is to learn how to check, remove and install the parts before starting to buy replacement parts.

Make sure that the company that you buy parts from give you a good return guarantee in case that you may need to return any parts.

WE recommend  Repair Clinic  for their 365 days return guarantee

Also take the purchase slip and the old part and put them in the box of the new part so in case you need to return any parts you will know where the box and the slip are.

This is the end of the noisy Maytag washer page.








Home Page




© Copyrighted 2017 2018 Angel Acevedo. All rights reserved